Home » Community » Work in progress » WIP - Sword (Need advice / help)
Search Search  
WIP - Sword (Need advice / help) [message #54834] Thu, 04 October 2012 04:09 UTC Go to previous message
avatar lorddragonmaster is currently offline lorddragonmaster
Messages: 18
Registered: January 2012
Go to my shop
Junior Member
Hello,

I am attempting to model a sword for the first time base off of one I saw in a cartoon.

The sword will be approx. 15cm in length.

My question is, as per the attached image, what is the minimum thickness my more delicate parts should be?

Mainly the yellow parts, and 4 arms from the hilt.

The square you see in the picture is 0.7mm, but I am kinda confused as to what is a good thickness to stick too for a plastic print?

Thanks for the help.

~LDM

http://i.imgur.com/pnDLu.jpg

Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Rubber Blaster iPhone 5 Case
Next Topic:What do you think of this?
Goto Forum:
   Go
Generate printable PDF   


Current Time: Thu May 23 20:36:23 UTC 2013