Home » Community » General Discussion » Any tips on simplifying a complex model???
Search Search  
Any tips on simplifying a complex model??? [message #54353] Fri, 21 September 2012 18:46 UTC Go to previous message
avatar JMG_01 is currently offline JMG_01
Messages: 5
Registered: August 2012
Go to all my models
Junior Member
I have a complex 3d engineering model and want to "print" something looking like it, but it does not have to be exact.

I know many details are too thin to print, and think the simplest would be if I could just make everything have a minimum dimension or stretch everything in 3 dimensions very slightly. I know it would end up less exact, but it should be good enough. Does anyone have any tips for a new beginner on how to do this in say MeshLab???
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Video about a new program that adds structural support as needed in your digital model automaticall
Next Topic:Gold-plated Lego Brick
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 18 15:41:35 UTC 2013