Home » Support » 3D Printing » Just how flexible is "Flexible Plastic"?
Search Search  
icon5.gif  Just how flexible is "Flexible Plastic"? [message #52823] Sun, 19 August 2012 11:18 UTC Go to previous message
avatar rune_kg is currently offline rune_kg
Messages: 4
Registered: August 2012
Go to all my models
Junior Member
So, I've finally managed to model a CardHolder using Sketckup. The holes are for an elastic band. The walls at their thickest is 2mm and then narrows down to 0.2mm.

I'm questioning if the walls will be flexible enough to hold about 1cm of bus- and credit cards between them? Do you have any insights about this?

Thanks a lot!!!!!
Rune
Report message to a moderator
Message index

Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Little People!
Next Topic:Maximum bed size and quote possible?
Goto Forum:
   Go
Generate printable PDF   


Current Time: Sat May 25 02:06:09 UTC 2013