Home » Community » Co-Creator Feedback » Wall thickness Issues
Search Search  
Wall thickness Issues [message #26374] Fri, 22 April 2011 15:40 UTC Go to previous message
avatar rawkstar320  is currently offline rawkstar320
Messages: 415
Registered: January 2009
Go to my shop
Senior Member
I recently had an order come through on my Card Carrier where the customer had actually contacted me ahead of time. After they ordered the personalized card carrier through Shapeways, I personalized it and sent it on its marry way.

Or so I thought...

The next day I received an email stating that "the order had been canceled" "this could have been due to the customer not paying, etc"

The customer in question then emailed me asking about what was supposed to happen, I then emailed Shapeways Service and was told that the model had some wall thickness issues. (The customer had been supplied with a coupon)

Now, this was an honest mistake, but I feel like there should be some sort of communication between me and Shapeways where as soon as they found the problem, they could have emailed me and I could have fixed it - if possible. If I fixed it, then I should be able to re-upload. If not, THEN the order should be cancelled.

I suppose the simple solution is just to "never make a mistake again" but that can't always happen.

My biggest concern is that several other of my orders may have actually been canceled for this reason - but I never knew why. I just assumed that they had trouble paying or something weird like that....

[Updated on: Fri, 22 April 2011 15:41 UTC]


Aut Viam Inveniam Aut Faciam
Check out http://JakeDrews.Com and http://WondrousWidgets.Com for more designs by Jake!

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Materials available
Next Topic:Automatic co-creators
Goto Forum:
   Go