Search Search  
Today's Messages (ON)  | Unanswered Messages (ON)

Forum: 3D modeler needed
 Topic: Modeling a custom Tablet Holder
Modeling a custom Tablet Holder [message #99567] Tue, 30 September 2014 21:52 UTC
avatar erikpeters  is currently offline erikpeters
Messages: 1
Registered: September 2014
Go to all my models
Junior Member
I have a car with a very ancient navigation system. I no longer can use it, and the screen inside is useless / old. I'd like someone to help model a tablet holder with the following requirements

Must Haves
it will stand/hold a 186mm tall tablet (LG G Pad 7.0), sideways (landspace mode)
clear the wooden panel that swings up/down
allow the tablet to be removable (it gets hot inside cars)
tablet + holder will not rattle (I can perhaps test some cloth)

Nice to haves
it will bolt into the original navigation screen mounts (see the ebay link for an idea, I can remove my OEM screen for you to measure)
allow clearance for the AUX thin cable (I will likely need to get a 90 degree AUX connector)
you live in the SF Bay Area (it would be nice to work face to face)

The old unit :
EBAY Link to old unit : on-GPS-LCD-Display-Screen-86111-24110-OEM-/160967745157

The new unit (aka the tablet) 006



We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.