Search Search  
Today's Messages (ON)  | Unanswered Messages (OFF)

Forum: 3D modeler needed
 Topic: Need small adjustment to project to make sure it prints
Need small adjustment to project to make sure it prints [message #94719] Fri, 25 July 2014 12:20 UTC
avatar nyc20  is currently offline nyc20
Messages: 2
Registered: July 2014
Go to all my models
Junior Member
I have a ring that is basically where I want it. When I use Shapeway's tool it says wall are too thin but it is not consistent in the part that its flagging. Attached is the .stl. Project was done through render and I can supply original file.

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.