Limited Time Offer: Get 10% off your own designs in 16 cast metal finishes · Learn More
Search Search  
Today's Messages (ON)  | Unanswered Messages (ON)

Forum: Work in progress
 Topic: Getting Past Maya and Ready to Print
Getting Past Maya and Ready to Print [message #111480] Wed, 04 March 2015 03:07 UTC
avatar joshuagilbreath  is currently offline joshuagilbreath
Messages: 5
Registered: October 2012
Go to my shop
Junior Member
Howdy all, I am needing a little help getting my models out of Maya and print ready. These chairs are intended to be used as Wedding Cake toppers, so I would like them only to be about 3.5-4 inches tall. I am also a little lost in regards to the best practice for shelling the two models.

Here is a preview of the chairs.
http://img.photobucket.com/albums/v611/agentjosh77/Chairs_Preview_zpskaftivvx.jpg

Any advice would be wonderful. I exported each chair as an OBJ but the model preview in the Shapeways webapp was pretty broken. I have attached the Maya file if anyone would like to review the file.

Thank you all! I appreciate the assistance!

  • Attachment: Up_Chairs.mb
    (Size: 1.87MB, Downloaded 1 time(s))

[Updated on: Wed, 04 March 2015 03:10 UTC]

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.