Home » Community » 3D modeler needed » 3D rendering of rings
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
3D rendering of rings [message #48497] Wed, 16 May 2012 00:57 UTC Go to next message
avatar Chrishh11  is currently offline Chrishh11
Messages: 4
Registered: May 2012
Go to all my models
Junior Member
I'm looking for someone to render some rings for me in 3D. The rendering will take a fair amount of attention to detail, but will hopefully be a fast process. If this works out I'll be looking to get quite a few rings rendered, so hopefully I can find someone I can work with.
thank you!
Re: 3D rendering of rings [message #48505 is a reply to message #48497 ] Wed, 16 May 2012 03:13 UTC Go to previous messageGo to next message
avatar CADNinja  is currently offline CADNinja
Messages: 219
Registered: March 2012
Go to my shop
Senior Member
PM sent


Inspire through Design, Create Solutions, Deliver on Promise
Re: 3D rendering of rings [message #48528 is a reply to message #48505 ] Wed, 16 May 2012 13:19 UTC Go to previous messageGo to next message
avatar MarcoA  is currently offline MarcoA
Messages: 16
Registered: September 2008
Go to my shop
Junior Member
No Message Body


MarcoA
http://marcoalici.wordpress.com/
Re: 3D rendering of rings [message #49236 is a reply to message #48497 ] Thu, 31 May 2012 18:01 UTC Go to previous message
avatar Eragatory  is currently offline Eragatory
Messages: 1
Registered: December 2010
Go to my shop
Junior Member
hello

are you still looking for someone to render your rings?
you can check my work on http://eragatory.blogspot.com/
my email adress can be found their as well, if you have any interest.

please feel free to contact me by "real" mail on that matter

best regards

 
   
Previous Topic:I have a pendant design that I need translated into a physical pendant
Next Topic:3D and 2D rendering needed for refrigerator magnet