Home » Community » General Discussion » Printing size and price
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Printing size and price [message #45933] Sat, 24 March 2012 21:47 UTC Go to next message
avatar PolygonAttack  is currently offline PolygonAttack
Messages: 2
Registered: March 2012
Go to my shop
Junior Member
Hi everyone, I need a little bit of help here.

I just uploaded a model and I can't figure out if the size is appropriate, the numbers look good but it's a little bit too expensive and when comparing to other models I get even more confuse.

This is my model, it should be about 11 cm high(it is hollow).

But then this one is 4cm high? Isn't it to small?

Can someone tell me if I'm doing something wrong here?

[Updated on: Sat, 24 March 2012 22:21 UTC]

Re: Printing size and price [message #45936 is a reply to message #45933 ] Sun, 25 March 2012 00:56 UTC Go to previous messageGo to next message
avatar skatersollie  is currently offline skatersollie
Messages: 33
Registered: July 2011
Go to my shop
Member
What's wrong with your link? can't even get the dimensions of your model..cost is also dependent on the material chosen..


http://www.skatersollie.com
Re: Printing size and price [message #45937 is a reply to message #45936 ] Sun, 25 March 2012 00:58 UTC Go to previous message
avatar PolygonAttack  is currently offline PolygonAttack
Messages: 2
Registered: March 2012
Go to my shop
Junior Member
I already got the answer i was looking for, ty anyway

 
   
Previous Topic:Double Secure Puzzle Ring
Next Topic:Customer Service