Home »  » 3D modeler needed » Gun barrel weight \ underlug needed
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Gun barrel weight \ underlug needed [message #44329] Wed, 22 February 2012 20:21 UTC Go to next message
avatar inferno  is currently offline inferno
Messages: 3
Registered: January 2011
Go to all my models
Junior Member
Approximately 6inch long weight needed to be modeled to be added under a revolver pistol barrel. must be precise measurements. can send barrel to model off of.
Re: Gun barrel weight \ underlug needed [message #44340 is a reply to message #44329 ] Wed, 22 February 2012 22:01 UTC Go to previous messageGo to next message
avatar inferno  is currently offline inferno
Messages: 3
Registered: January 2011
Go to all my models
Junior Member
Sorry, i just realized a 6 inch long piece would be $300+ in stainless steel, so i am cancelling this project.
Re: Gun barrel weight \ underlug needed [message #44368 is a reply to message #44340 ] Thu, 23 February 2012 12:49 UTC Go to previous messageGo to next message
avatar mctrivia  is currently offline mctrivia
Messages: 808
Registered: September 2010
Go to my shop
Senior Member
can be machined on CNC for much less


Follow me on twitter http://twitter.com/mctrivia or my blog at http://4ddice.blogspot.com/
Re: Gun barrel weight \ underlug needed [message #44385 is a reply to message #44368 ] Thu, 23 February 2012 16:10 UTC Go to previous messageGo to next message
avatar inferno  is currently offline inferno
Messages: 3
Registered: January 2011
Go to all my models
Junior Member
do you have any suggestions for where to get this single item CNCd? thanks!
Re: Gun barrel weight \ underlug needed [message #44406 is a reply to message #44329 ] Thu, 23 February 2012 23:43 UTC Go to previous messageGo to next message
avatar animerb  is currently offline animerb
Messages: 10
Registered: January 2012
Go to all my models
Junior Member
you might look into finding a local gunsmith. they would likely have all the tools needed for such a project
Re: Gun barrel weight \ underlug needed [message #44500 is a reply to message #44406 ] Sun, 26 February 2012 13:50 UTC Go to previous message
avatar Twopounder  is currently offline Twopounder
Messages: 71
Registered: December 2011
Go to my shop
Member
Yeah, a gunsmith is highly advised, not just for cost/experience reasons, but also safety.


http://fracturedmesh.blogspot.com/ - my 3d modeling blog

 
   
Previous Topic:Radio parts designer in southern CA
Next Topic:Need 3D Models of Plants

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.