| Silver Design Rules [message #42594] Mon, 23 January 2012 21:12 UTC |
|
|
Whats up everyone. I have a question on a possible workaround. In the design rules for silver it shows a maximum height of 30mm. My question is for my skull ring in my shop. lets say i make it 35 mm from chin to top of head. If I angle the 3d model back about 45 degrees so that the height changes down to 30mm while still keeping the rings dimensions the same (meaning the skull will remain 35mm from chin to top of head). will this be OK?
----------------------------------------------------------------------------------------------------------------
- Sal G -
My Website
www.sgcustomsilver.com
Facebook Page
www.facebook.com/SGCustomSilver
|
|
|
Search
