Shapeways USA just announced 14k Gold, read more on the blog
Home » Community » 3D modeler needed » Need designer to "hollow out" 3D files
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Need designer to "hollow out" 3D files [message #42090] Tue, 17 January 2012 05:00 UTC Go to next message
avatar 535852a7fa  is currently offline 535852a7fa
Messages: 1
Registered: January 2012
Go to all my models
Junior Member
Greetings Shapeways members,

I am considering getting 3D scans of prototype wargaming miniatures produced through Shapeways.

I am pretty sure I can handle the process of getting the models scanned but I will need help on getting these files print ready, which will include hollowing them out to save cost.

Is there a designer here that would work on a per model basis. I am trying to figure out what the cost would be for this service.

I can be reached at jodeebenavides@yahoo.com

Best regards,

Jodee
Re: Need designer to "hollow out" 3D files [message #42098 is a reply to message #42090 ] Tue, 17 January 2012 07:58 UTC Go to previous message
avatar Twopounder  is currently offline Twopounder
Messages: 70
Registered: December 2011
Go to my shop
Member
I'm not quite at the point where I can claim to be a great artist, but there a modeler named John Bear Ross who specializes in this kind of stuff. You can contact him at johnbearross@gmail.com or check out his site at http://johnbearross.com/.

Good luck!


http://fracturedmesh.blogspot.com/ - my 3d modeling blog

 
   
Previous Topic::Completed: Help needed tweaking existing files, will pay.
Next Topic:3d modeler needed for small custom enclosure