Home » Community » 3D modeler needed » 30mm Blood Bowl figures
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
30mm Blood Bowl figures [message #41630] Tue, 10 January 2012 18:44 UTC Go to next message
avatar islandtrevor  is currently offline islandtrevor
Messages: 5
Registered: September 2011
Go to my shop
Junior Member
I am looking for someone to clean/repair my models. Sadly, as I am on a budget, I need estiamtes first (please in american or canadian currency).

I included an obj showing just how badly I have made the model and a few images to show what my desires are.

This obj is one of 16 models. Of the 16 there are 4 basic body designs(shown in the picture BBsize) which are in differing poses. The models will range from 30mm to 35mm tall and be printed in solid FUD. I am not sure what is easier, cleaning 16 meshes or cleaning the 4 and posing them as I have. I can provide the 4 templates objs, each looking as they do in the BBsize image and a posed obj of all 16. What I am looking for is a single surface mesh where the clothing is completely connected to the body suitable for printing. (I can provide objs of each individual part of this model if needed). I can go into greater detail but for an estimate I do not wish to waste your time.

There will also be a second set of 17 models in 2 body shapes. One is 32mm the other is 40mm. This one will require a bit of modeling. First the back will have a plate in the shape of a maple leaf (positioned like the round one in the BBBlitzer obj) which will have numbers. The second is an extrusion what will appear as a form fitted clothing along the green lines in the CMtemplate image. As well the maple leaf will extrude the same distance as the sides. I hope I am explaining that well. Again I can go into greater detail.

I am not sure if I will include bases or not yet. If I do these will have to be added to the model.

I do thank you for your time in looking at these and hope I am able to find someone to work with.

BBsize by Islandtrevor, on Flickr

CMtemplate2 by Islandtrevor, on Flickr

  • Attachment: BBblitzer.obj
    (Size: 16.71MB, Downloaded 28 time(s))

Re: 30mm Blood Bowl figures [message #41848 is a reply to message #41630 ] Fri, 13 January 2012 06:35 UTC Go to previous message
avatar Jackablade  is currently offline Jackablade
Messages: 11
Registered: January 2012
Go to all my models
Junior Member
I'm having a look over your model. It looks like it shouldn't be hugely complicated to fix. Do you still have the model from before it was subdivided? That'd make things a lot simpler and would factor into the amount of time needed to do the changes to each model significantly.

Previous Topic:Modeling a 3d colorspace
Next Topic:Modeler needed for organic 3D model