Home » Support » 3D Printing » Minimum Dimensions
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Minimum Dimensions [message #41550] Mon, 09 January 2012 22:06 UTC
avatar AyameDeude  is currently offline AyameDeude
Messages: 9
Registered: December 2011
Go to my shop
Junior Member
Hello fellow Shapies!

I submitted an order for one of my models so I could take some photos and I received a "dimensions too small" notice about it.

As far as I can tell, the dimensions of both earrings fit in the minimum 65mm total. Though, admittedly, only when accounting for both earrings.

Link to model: http://www.shapeways.com/model/426629/minecraft_earrings__gr ass_.html?gid=ug

Is there something I'm missing or is it a mistake? I can increase the size of the earrings easily enough, but I really like the current size of them and am worried that it will come out gaudy.

Note: the original design was two cubes of 16x16x16mm each. i recently ugraded them to be 22x22x22mm in hopes that it would fulfill the 65mm minimum.

[Updated on: Tue, 10 January 2012 00:11 UTC]

Previous Topic:Too expensive??
Next Topic:Fixing uploaded models