Hi fellow shapies! I just finished making this last night and I really like the way it looks and ends up hanging when worn so, I am hoping that this could be featured if only for a while.
To be featured, you should get it printed and have pictures of it first. This would have to be printed in Full Color Sandstone to have the color, and I'm not sure you have enough material around the hole to meet the requirements for it to be printed. Check to make sure it follows these rules http://www.shapeways.com/design-rules/full_color_sandstone order it, and get some good pictures of the final result.The Mad Moder
michael@shapeways.com
I put in an order for some of my models earlier this morning. I'm fairly sure that it meets the requirements for printing as I was double checking a lot of my measurements as I was going along.
I'll get some better pictures in once my prints arrive. Hopefully all goes well considering I'm really new to this 3D rendering/printing scene.
Search
