Now Through Sunday Night. Black Friday Deals & Free Shipping! See the deals.
Home » Community » 3D modeler needed » Need Modeler for "Christmas Ornament" tpe project
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Need Modeler for "Christmas Ornament" tpe project [message #38250] Wed, 09 November 2011 18:00 UTC Go to next message
avatar gaaypdx  is currently offline gaaypdx
Messages: 2
Registered: September 2010
Go to all my models
Junior Member
Looking for lightweight ball shaped open design, logo on one side and rose on other side (if possible)- "see through" hollow style and hanger/connector on top. (low definition of two sides attached). Must be clean and ready to upload to Shapeways for production as I have NO competency, just ideas. These are holiday gifts for a non-profit in 2012. SSeibert@LHS.org index.php?t=getfile&id=11887&private=0

  • Attachment: ball.JPG
    (Size: 37.95KB, Downloaded 174 time(s))

[Updated on: Wed, 09 November 2011 18:01 UTC]

Re: Need Modeler for "Christmas Ornament" tpe project [message #38253 is a reply to message #38250 ] Wed, 09 November 2011 18:42 UTC Go to previous message
avatar mctrivia  is currently offline mctrivia
Messages: 808
Registered: September 2010
Go to my shop
Senior Member
can not be made clear on shapeways. could be made of colored sand stone.

1 1/4" ball diameter would cost about $6 each. can make model for $15 but you need to give me proper dimensions for hanger neck as I don't have any

[Updated on: Wed, 09 November 2011 18:43 UTC]


Follow me on twitter http://twitter.com/mctrivia or my blog at http://4ddice.blogspot.com/

 
   
Previous Topic:A request
Next Topic:A Quick & Easy Favor

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.