Home » Support » 3D Applications » Is the Stainless Steel from shapeways magnetic?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Is the Stainless Steel from shapeways magnetic? [message #38038] Sat, 05 November 2011 22:28 UTC Go to next message
avatar 132a490878  is currently offline 132a490878
Messages: 1
Registered: November 2011
Go to my shop
Junior Member
Is the Stainless Steel from shapeways magnetic? i want to use it to make a stator for a brushless motor
Re: Is the Stainless Steel from shapeways magnetic? [message #38058 is a reply to message #38038 ] Sun, 06 November 2011 09:29 UTC Go to previous message
avatar stop4stuff  is currently offline stop4stuff
Messages: 3006
Registered: June 2010
Go to my shop
Senior Member
Yes, but from experience I'd say only about 50% the magnetic susceptability of plain steel, you might notice some drop in performance due to reduced flux saturation levels. SW SS also retains some magnetism after a magnet has been removed.


 
   
Previous Topic:Blender 2.5 and shapeways
Next Topic:Simple .wrl viewer