| How to make a customizable design [message #20837] Tue, 23 November 2010 10:25 UTC |
 |
|
Hi!
I'm sure this issue has been explained somewhere here before, but I could not find it, I apologize
Let say I have designed a ring with specific inned diameter, which I want to be customizable..
Should I upload 10 different rings so 10 diameters can be picked up or there's a smarter way?
Thank you
www.ad-3d.com
|
|
|
|
| Re: How to make a customizable design [message #20853 is a reply to message #20841 ] Tue, 23 November 2010 18:22 UTC |
 |
|
Duann, thanks a lot !
www.ad-3d.com
|
|
|
| Re: How to make a customizable design [message #20854 is a reply to message #20837 ] Tue, 23 November 2010 18:31 UTC |
|
|
Also note that you want to specify your max volume at the largest ring size. Just so you don't have a ring ordered that would have to be impossibly thin to match the design to be at or under your set max volume.
The Mad Moder
michael@shapeways.com
|
|
|
|
| Re: How to make a customizable design [message #21543 is a reply to message #20855 ] Sat, 11 December 2010 16:30 UTC |
|
|
I just experienced this the hard way, I had three bands up in a size 10 US,
Very sizable for any size. I set up templates ,I bumped the volume up a bit not thinking how it would change the price on all pieces. I wanted to order samples to photograph.Even some in plastic, my Order came out to be much higher, to me. almost $20 US more than it should, my only fix was to delete the models reload reorder. Once I have my photos I will make them and customizable again. I think I will make it sizable smaller only.
Btw I do love Shapeways.
Devlin
[Updated on: Sat, 11 December 2010 16:31 UTC]
|
|
|
|
Search
