Home » Community » Introductions » Hello
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Hello [message #20736] Fri, 19 November 2010 13:33 UTC Go to next message
avatar maxenin is currently offline maxenin
Messages: 2
Registered: November 2010
Go to all my models
Junior Member
Hi,

Im new here well I guess that goes without saying Razz but i was wondering if I have a question about the materials under which forum should i put it? thx everyone
Report message to a moderator
Re: Hello [message #20737 is a reply to message #20736 ] Fri, 19 November 2010 13:42 UTC Go to previous message
avatar Youknowwho4eva is currently offline Youknowwho4eva
Messages: 4075
Registered: September 2008
Go to my shop
Senior Member
I work here
Welcome,

It semi depends on your question. If it's about design limitations, then it would go in the 3D Design. If it's about the material or process, then 3D printing would be the place.

The Mad Moder
michael@shapeways.com
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Hello, new here !
Next Topic:Hello from NorCal