Home » Support » 3D Design » whys this costing $300+
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
whys this costing $300+ [message #12442] Mon, 03 May 2010 22:00 UTC Go to next message
avatar TinyTerrain  is currently offline TinyTerrain
Messages: 1
Registered: April 2010
Go to all my models
Junior Member


I am a complete newb...why is this comming out at $300 + when its just 7.5cm long? What have I done wrong? How do I correct it please?


Cheers, Craig

  • Attachment: house2.stl
    (Size: 1.64KB, Downloaded 88 time(s))

[Updated on: Mon, 03 May 2010 22:00 UTC]

Re: whys this costing $300+ [message #12443 is a reply to message #12442 ] Mon, 03 May 2010 22:37 UTC Go to previous message
avatar gibell  is currently offline gibell
Messages: 375
Registered: May 2009
Go to my shop
Senior Member
It is solid. A brick 5.6 cm x 7.5 cm x 6.1cm has volume 256.2 cm^3. Since the cost is $1.50 per cm^3, $300 sounds right.

If you hollow it out, should be a lot cheaper.

Previous Topic:3D viewer errors
Next Topic:stainless steel strength