Strange manifold problems / Sketchup - 3D Applications on Shapeways Discussions about 3D Printing

Home » Support » 3D Applications » Strange manifold problems / Sketchup

Strange manifold problems / Sketchup [message #10075] Sat, 20 February 2010 18:44 UTC

Jelle Marechal
Messages: 2
Registered: February 2010
Go to all my models

Junior Member

Hi all,

i've been trying to make a model but haven't been able to submit it mostly because of manifold errors. I've found the culprit though, it's because of the roof in my model.

But, when I inspect my model in the Model Error Analysis, it doesn't give me any red areas. I'm also pretty sure my model is waterproof (even Accutrans says so..)

why does it keep on giving me these manifold errors? (i've checked internal overlappings already as well..)

Would anyone be willing to look at my model? As the topic title suggests, I made this model in sketchup. i'm out of ideas, i really can't figure it out...

thanks in advance!

cheers

Attachment: ophoopvanzegen.stl
(Size: 38.46KB, Downloaded 92 time(s))

Report message to a moderator

Profile PM

Reply Quote

Re: Strange manifold problems / Sketchup [message #10087 is a reply to message #10075 ] Sun, 21 February 2010 12:29 UTC

aoster
Messages: 12
Registered: November 2009
Go to all my models

Junior Member

Hi there,
As you see in the picture, there was an additional plane inserted on top of the walls which does not contribute to the boundary surface (the green one).