Hey there, I`m an absolute beginner in 3d Programms. I try to make a ring with engraving and used Tinkercad and it almost worked, but when I will print the diameter of the ring is too big. Inside it should be 17mm and the wide should be 1mm. And I don't`t know if it is really engraved.... Would be perfect if anybody could have a look I`m looking forward to your answers. Greetz, Sina
Hello, I imported into MeshLabs, exported as .3ds and imported into SketchUp, resized the width to 17mm and it uploads fine my end, not sure what you meant by "and the wide should be 1mm" but for now: Tom.