Uploading Issues

Discussion in 'Software and Applications' started by 260736_deleted, Oct 14, 2013.

Thread Status:
Not open for further replies.
  1. I have created a simple low-poly style cup in Cinema 4D R13. I have exported it in .stl / .obj / VRML 2 and I have also tried using mesh lab to make sure the model was clean and good to go. I have also tried triangulating the model in aforementioned formats. When I upload the model here on shapeways I get a "failure" message, but with no feedback regarding as to why it has failed. I tried uploading the same model to competitive service and it uploaded in less than a minute, no problems (the OBJ format).

    Am I missing a step that shapeways needs, or is there a problem on their end with their uploader?

    ** I dont post frequently, so if this needs to be moved to a different forum, so be it...

     
  2. mkroeker
    mkroeker Well-Known Member
    There have been intermittent problems with the upload here since about a week ago.
     
  3. Thanks. I would suspect they are working on this issue at the moment then.
     
  4. Youknowwho4eva
    Youknowwho4eva Well-Known Member
    Last edited: Oct 14, 2013
Thread Status:
Not open for further replies.