Home » Support » Bug Reporting » Design Printability Validation Service
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Design Printability Validation Service [message #7724] Wed, 11 November 2009 15:29 UTC
avatar B1lancer  is currently offline B1lancer
Messages: 117
Registered: May 2009
Go to my shop
Senior Member
Quite a few models I produce I want myself so I am happy to buy the initial test print, however some I don't want and I end up printing a test model that I don't really want just to make sure the customer won't get the "Model too thin to print" error etc. Normally it's an error I can correct in a couple of mins.

What I'd like is a service which costs maybe $10-15 where your model is sent to the operators and they check to see if it will print and then send you a confirmation telling you the model will print without any problems or if problems are found how to rectify them followed by a re-check.

Kindest Regards, Jack


 
   
Previous Topic:featured shop models -- why?
Next Topic:Site Translation