Home » Community » 3D modeler needed » Designer for Corbels for door frame.
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Designer for Corbels for door frame. [message #71898] Sat, 20 July 2013 11:42 UTC Go to next message
avatar pablo  is currently offline pablo
Messages: 1
Registered: August 2008
Go to all my models
Junior Member
I am getting a door and frame made up to match a neighbour's door. I want to get the corbels3d printed similar to what he has.

I know Ideally I would need to remove one of his corbels and get it scanned in 3d scanner but this is not possible.

If I was to photograph from front and side and give dimensions would someone be able to create a close replica which I can then go and organise a 3d print of? Or is there a special camera I should use / get someone locally to operate?

Would suit someone in Dublin, Ireland or perhaps a design is achievable from any location (once certain action is done at this end).

Any suggestions welcome.


Re: Designer for Corbels for door frame. [message #71902 is a reply to message #71898 ] Sat, 20 July 2013 15:15 UTC Go to previous message
avatar sorhain  is currently offline sorhain
Messages: 29
Registered: October 2012
Go to my shop
Junior Member
I sent a pm

[Updated on: Sat, 20 July 2013 15:16 UTC]

www.corinnehansen.com sorhain@gmail.com

Previous Topic:Disney Stitch case for HTC EVO 3d
Next Topic:Design Help With Head Bust