Home » Community » 3D modeler needed »

3D modeler needed for a battery holster adapter prototype

Search Search  
Show: Today's Messages    Show Polls    Message Navigator
3D modeler needed for a battery holster adapter prototype [message #64728] Sat, 23 March 2013 20:52 UTC Go to next message
avatar mikelee  is currently offline mikelee
Messages: 0
Registered: March 2013
Go to all my models
Junior Member

I need someone to help me make a holster clip adapter where these Ryobi batteries (found from Home depot) clip into each other as seen in picture
It must be able to maintain enough room and functionality where the electrical terminals make proper contact.

Pls don't make this more complicated then it is. The batteries in the picture are laid out exactly how I want it to clip into each other. Just fill in the space between the battery with the housing that I need for you to design.

must be willing to sign an NDA


[Updated on: Thu, 28 March 2013 01:40 UTC]

Re: 3D modeler needed for a battery holster adapter prototype [message #64738 is a reply to message #64728 ] Sun, 24 March 2013 02:57 UTC Go to previous message
avatar CADNinja  is currently offline CADNinja
Messages: 241
Registered: March 2012
Go to my shop
Senior Member
Private message sent

Previous Topic:Need someone Specializing in simple modern, clean design
Next Topic:resize required



We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.