Introducing 14k Gold, read more on the blog.
Home » Community » General Discussion » Can I wash my plastic model?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Can I wash my plastic model? [message #64681] Fri, 22 March 2013 20:12 UTC Go to next message
avatar GarySG  is currently offline GarySG
Messages: 92
Registered: September 2012
Go to my shop
Hi awesome 3D community, i'm just wondering if anything drastically bad would happen if I rinsed off my model printed in red plastic, thanks!

"Hm, I'm so hungry I could eat an entire cow. Gerard, fire up the printer!"
Re: Can I wash my plastic model? [message #64743 is a reply to message #64681 ] Sun, 24 March 2013 09:04 UTC Go to previous messageGo to next message
avatar joe1029  is currently offline joe1029
Messages: 18
Registered: August 2012
Go to my shop
Junior Member
Speaking from personal experience, I haven't seen any difference even showering in my black strong and flexible plastic earrings.

I haven't washed anything in red yet though.
Re: Can I wash my plastic model? [message #64821 is a reply to message #64681 ] Mon, 25 March 2013 13:08 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5115
Registered: September 2008
Go to my shop
Senior Member
I work here
With our dying process, the colors shouldn't run. I do have an Alumide piece that my thumb was wet when I touched it, and you could see for a long time where I touched it. But with dyed SF the pores are mostly filled with the dye and shouldn't absorb much water.

The Mad Moder

Previous Topic:Parametric Parts
Next Topic:3d printers for limited mass production