Simple revolved shape request

Discussion in '3D Design Requests' started by 248094_deleted, Mar 20, 2013.

  1. Hello,

    I'm looking to have a simple revolved shape 3D printed, but since I have very little experience with modelling, I was hoping someone could help me here.

    I have attached a photo of the shape I need. The blue line is the axis to revolve around, and the black is the profile. The finished shape should be approximately 2" tall.

    Would anyone be willing to do this for me?

    Thank You,

    Untitled-23-01.jpg
     
    Last edited: Mar 20, 2013
  2. elopez3d
    elopez3d Well-Known Member
    Hello Drew,

    I'd be willing to do this for ya, 2 minute job really.

    Do you want this hollowed? (to save cost on printing material)

    If so you'll need a drainage hole, let me know what kind material you'd like this printed in and I'll set it up.

    Regards,
    Eric Lopez
     
    Last edited: Mar 21, 2013
  3. Keymaker
    Keymaker Well-Known Member
    Hi
    I can do this for 5€ for you.
     
  4. Hi Eric,

    Thank you for your offer to do this for me, I appreciate it a lot!

    Hollow will be fine. If it's ok, please put the hole about 1/4" up from the bottom.

    Fine Detail Plastic, White.

    Thank you!
     
    Last edited: Mar 21, 2013
  5. elopez3d
    elopez3d Well-Known Member
    Hi Drew,

    Happy to help, I'll send you the file over PM.

    Regards,