Home » Community » General Discussion » model could not be print (i use SketchUp)
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
model could not be print (i use SketchUp) [message #64402] Tue, 19 March 2013 02:38 UTC
avatar cnomis  is currently offline cnomis
Messages: 11
Registered: July 2011
Go to my shop
Junior Member
Embarassed i m newbie of here & SketchUp either, i wanna do a ball joints (like that use on Revotech toys)connect around a spin.

after lots of study, i hollow 6 hole on the spin, however, due to the thin wall issue, it could not be printed. i dunno how to fix it in my limited knowledge of 3D. so i post & hope u seniors could advice or fix it for me.

i just miss this one to complete my set, so poor. i ll appreciate if any one help. thx a lot.

here s the file:


  • Attachment: 553100.JPG
    (Size: 50.56KB, Downloaded 19 time(s))

Previous Topic:Ring size discrepancies in different materials
Next Topic:Help for student, please: why 3d printing ?