Home » Support » 3D Printing » How much detail can I expect?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
How much detail can I expect? [message #61107] Thu, 31 January 2013 12:41 UTC Go to next message
avatar alolkoy_designs  is currently offline alolkoy_designs
Messages: 1
Registered: March 2011
Go to my shop
Junior Member
This may be hard to answer, but here goes.

If I make a 3D relief of a person's face (cameo). How small could I go and reasonably expect the face to be recognizable?


Re: How much detail can I expect? [message #61116 is a reply to message #61107 ] Thu, 31 January 2013 15:17 UTC Go to previous message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5107
Registered: September 2008
Go to my shop
Senior Member
I work here

Check out our materials page. It will depend on your material. Our highest detail material is FUD (listed as Frosted Detail Plastic), which has an accuracy of ±0.025-0.05mm for every 25.4mm

The Mad Moder

Previous Topic:Talk detail with me ;)
Next Topic:Lost wax process - which material will melt easiest/cleanest