Home » Community » 3D modeler needed » complete my keyboard
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
complete my keyboard [message #60459] Mon, 21 January 2013 02:59 UTC Go to next message
avatar Tamfang  is currently offline Tamfang
Messages: 13
Registered: April 2012
Go to my shop
Junior Member
Yesterday I coughed while drinking cocoa at my desk. You know what that means!

I pulled all the keys from my Microsoft Natural 4000 keyboard and washed them, and also took the occasion to clean out accumulated crumbs, hairs and general dust. Once the keys were dry, I put them back ... and found that the agents of chaos (contributors of some of the aforementioned hairs) had hidden the 'W' and 'Del' keys.

Since it's only $50 to replace the whole keyboard, I don't suppose it would be worthwhile to design replacements for those specific keys; but I'll bet you could make a small key that would fit most of the 'slots' on the board. I can't be the only one who'd use them!

[Updated on: Mon, 21 January 2013 03:00 UTC]

Re: complete my keyboard [message #60476 is a reply to message #60459 ] Mon, 21 January 2013 17:12 UTC Go to previous messageGo to next message
avatar JACANT  is currently offline JACANT
Messages: 543
Registered: July 2011
Go to my shop
Senior Member
PM sent


jacantdesign@gmail.com
Re: complete my keyboard [message #60496 is a reply to message #60476 ] Tue, 22 January 2013 07:24 UTC Go to previous message
avatar Tamfang  is currently offline Tamfang
Messages: 13
Registered: April 2012
Go to my shop
Junior Member
(PM not helpful.)

All my keys eventually turned up, so this is now a suggestion rather than a request!

I tried replacing vital keys with some that I never use (PrtScn/SysRq, ScrLk) but, curiously, they didn't move properly.

 
   
Previous Topic:Modeler needed to design Rubiks Cube tiles
Next Topic:Military ships, planes, tanks to model