Home » Community » 3D modeler needed » modeler needed to turn logo into 3d
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
modeler needed to turn logo into 3d [message #60249] Tue, 15 January 2013 09:37 UTC Go to next message
avatar simonallchorn  is currently offline simonallchorn
Messages: 1
Registered: December 2012
Go to all my models
Junior Member
I have a quite complex logo that was generated ages ago. I need this simplified to print as a round slightly domed button approx 32mm wide. Any help greatly received. Png attached but have svg etc

Thanks to everyone that showed an interest. All sorted now

  • Attachment: crest.png
    (Size: 236.19KB, Downloaded 100 time(s))

[Updated on: Wed, 16 January 2013 06:20 UTC]

Re: modeler needed to turn logo into 3d [message #60253 is a reply to message #60249 ] Tue, 15 January 2013 11:48 UTC Go to previous message
avatar Dotsan  is currently offline Dotsan
Messages: 356
Registered: August 2008
Go to my shop
Senior Member
Hi I'd like to help you with this, I have experience with domed buttons with reliefs.

My Shapeways reviews

3D Printed Silver Pendant by Dot San, on Flickr

Expertise: Models created, checked, repaired, shelled and colored

Experience: 10yrs+
Portfolio: Dot San
Flickr: Dot San on Flickr
Rate:Fixed rate,no two jobs are the same,email to discuss
Shapeways Interview
Society 6

We like challenges, so don't be shy in coming forward with any questions. Please feel free to contact my customers below for a reference.

Your ideas modeled and checked for 3D Printing by Dot San by Dot San, on Flickr


Previous Topic:3D Modeler needed for a Green Lantern ring
Next Topic:Xacti CA-100 camera (helmet) mount needed