|
| Re: FORMULA ONE PROJECT [message #59375 is a reply to message #59368 ] Sun, 30 December 2012 19:11 UTC |
  |
|
Looking at the dimensions of the overall model on the model page, I do not think you will get a successful print in any of the materials you have available for the model.
What are the wall thicknesses for the front supension arms ( = wires) and the panels on the front wing?
Paul
|
|
|
|
| Re: FORMULA ONE PROJECT [message #59378 is a reply to message #59376 ] Sun, 30 December 2012 19:59 UTC |
|
|
0.5mm for the front suspension arms would only be printable in Frosted Ultra Detail and then there's the probability that the model would not survive intact due to the mass that the thin parts need to support.
Paul
|
|
|
| Re: FORMULA ONE PROJECT [message #59379 is a reply to message #59378 ] Sun, 30 December 2012 20:01 UTC |
|
|
|
mmm yes i think the minimum need to be 0.7 ? so i will make some modification on it
|
|
|
| Re: FORMULA ONE PROJECT [message #59382 is a reply to message #59379 ] Sun, 30 December 2012 20:14 UTC |
|
|
0.7mm is the minimum for Strong & Flexible - even 1mm 'wire' is very flexible, for ridigity and printability in all but Ceramic, I'd be thinking somewhere up around the 1.5mm mark for the suspension wires and 1mm for the wings and rear under tray parts.
Paul,
|
|
|
Search
