Home » Support » 3D Printing » Appendages on ceramic models
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Appendages on ceramic models [message #58707] Mon, 17 December 2012 00:55 UTC Go to next message
avatar r2davis2  is currently offline r2davis2
Messages: 1
Registered: December 2012
Go to all my models
Junior Member

I'm trying to figure out if a model would print properly using the ceramic material wondered if anyone might have some advice. Here is a link http://www.shapeways.com/model/832842/dad-gift.html?li=my-mo dels&key=df5a36717cccc0ee650168c02364c4a0

Re: Appendages on ceramic models [message #58802 is a reply to message #58707 ] Tue, 18 December 2012 09:54 UTC Go to previous message
avatar stop4stuff  is currently offline stop4stuff
Messages: 2991
Registered: June 2010
Go to my shop
Senior Member
The appendages look good to print. If your item is a similar size to a cup, then the appendages look about the same as the cup's handles would be.


Previous Topic:3d print with texture
Next Topic:Errors after customer has paid :(