I recently uploaded a model created in Inventor Fusion to SW; it is an STL file, the model was created in milimeters and so I selected milimeters for the model upload. After the model uploads, the dimensions are incorrect- see the screenshot below: In the foreground is a screenshot of the model in fusion- you can see it is 169mm x 68.37mm. Behind that you can see a screenshot of the model in SW, it is only showing the model to be 1.65cm x .0684cm x .09cm What is going on- is anyone else having this problem??
Looks to me as if your software is exporting in cm. My math is fuzzy on Monday mornings, but I think that would cause the results. Try scaling up by 10 before exporting.