Home » Community » 3D modelers for hire » Gear ring, stirring weel, bike pedal weel: Who wants to make it?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Gear ring, stirring weel, bike pedal weel: Who wants to make it? [message #57152] Tue, 20 November 2012 14:42 UTC Go to next message
avatar teofend is currently offline teofend
Messages: 1
Registered: November 2012
Go to all my models
Junior Member
Hello,

who can make me 3d modelsof these, what would you need for this and how much would it cost?

Gear 5TH 25 teeth Transmission T-5
-> has to be fit to run in a car engine
http://imageshack.us/photo/my-images/15/gearkw.jpg/

Stirring weel
->For a car.
http://imageshack.us/photo/my-images/706/carstirringweel.jpg /

SRAM Bike pedal weel Apex, black, 175mm, 46-38T, 401000279
http://imageshack.us/photo/my-images/856/bikeh.jpg/

Thanks!
Report message to a moderator
Re: Gear ring, stirring weel, bike pedal weel: Who wants to make it? [message #57231 is a reply to message #57152 ] Wed, 21 November 2012 12:29 UTC Go to previous message
avatar bartv is currently offline bartv
Messages: 1111
Registered: December 2007
Go to my shop
Senior Member
I work here
teofend wrote on Tue, 20 November 2012 14:42

Gear 5TH 25 teeth Transmission T-5
-> has to be fit to run in a car engine
http://imageshack.us/photo/my-images/15/gearkw.jpg/


I'll need to insert a warning here: our steel quality is not certified to be used as a mechanical part in an engine - it would be dangerous to use it!

Bart

Community Manager Europe | Shapeways
Report message to a moderator

 
   Generate printable PDF   
   
Previous Topic:Cheap Designer For hire
Next Topic:Advanced Mechanical Modeler