Modeler wanted for 12cm Pony Figure - 3D modeler needed on Shapeways Discussions about 3D Printing

Shop

Join

Home » Community » 3D modeler needed » Modeler wanted for 12cm Pony Figure

Modeler wanted for 12cm Pony Figure [message #55620] Thu, 18 October 2012 20:46 UTC

RehydratedFruit
Messages: 1
Registered: October 2012
Go to all my models

Junior Member

Hi,

I'm looking for a modeler to design a full colour 12cm sandstone model from the picture attached.
The model would be that pony in that pose, I have other pictures for references too.
If you are interested please estimate a cost which includes the cost of construction and how long it would take.
I will have a look through your previous work as references.

Thanks!

Jay

Attachment: dat_flank_by_sexytalkischeap-d5387s5.png
(Size: 496.33KB, Downloaded 58 time(s))

Report message to a moderator

Profile PM

Reply Quote

Re: Modeler wanted for 12cm Pony Figure [message #55633 is a reply to message #55620 ] Fri, 19 October 2012 01:51 UTC

Ming
Messages: 71
Registered: May 2009
Go to all my models

Member

hi,
i'm a 3d modeler for over 15 years and have don tons of similar over the years .
i can model almost anything similarly based on references provided Smile