Home » Support » 3D Design » Edge radius for sharp edges to look and feel 'good'
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Edge radius for sharp edges to look and feel 'good' [message #54769] Wed, 03 October 2012 00:42 UTC Go to next message
avatar lanceatkins  is currently offline lanceatkins
Messages: 5
Registered: September 2012
Go to my shop
Junior Member
Hi Shapewaysers!

Quick question... I'm preparing a part for printing with colored strong&flexible. The part is going to have 'sharp' edges, and I currently have them designed with 90 degree bends and no radius to ease the edge. I have a feeling those crisp edges might end up feeling sharp and gritty... is this true? Is there a small radius you could recommend to keep the edges looking crisp (for cosmetic reasons), but also remove any harsh "feeling" to the edges? Or maybe there's just some magic-ish number you would recommend just works best in 3d applications? Cheeeeeeers!
Re: Edge radius for sharp edges to look and feel 'good' [message #54783 is a reply to message #54769 ] Wed, 03 October 2012 12:44 UTC Go to previous messageGo to next message
avatar Youknowwho4eva  is currently offline Youknowwho4eva
Messages: 5391
Registered: September 2008
Go to my shop
Shapie Expert
I work here
A sharp angle will come out fairly sharp. Really any radius on there would be good, as long as you make it at least the minimum detail size for WSF. I'd say at least .2mm.


I learned a long time ago the wisest thing I can do is be on my own side, be an advocate for myself and others like me. -Maya Angelou
michael@shapeways.com
Re: Edge radius for sharp edges to look and feel 'good' [message #54840 is a reply to message #54783 ] Thu, 04 October 2012 07:56 UTC Go to previous message
avatar Dragoman  is currently offline Dragoman
Messages: 173
Registered: August 2011
Go to my shop
Senior Member
A 90 degree angle is not going to feel sharp for most cases. Strong Flexible material is always a bit rough no matter how you curve it.

The only case where I would worry about a 90 degree edge if it's in permanent contact with skin, say the inside of a ring or bracelet. There I would agree with Youknowwho4eva

Greetings
Dragoman

 
   
Previous Topic:Inconsistent acceptance/rejection
Next Topic:Are These Edges Okay Or Not?

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.