These are the instructions for the following sets:
ETS35001
ETS35002
ETS35003

The next post holds the instructions for ETS35007, the Renault R35 set

Some general (hopefully useful) thoughts on working with printed parts made of 'Frosted Ultra Detail' can be found at the bottom of this message. We recommend you read this before ordering an item.



__________________________________

• Attachment: ETS35 working with FUD.JPG
  (Size: 657.99KB, Downloaded 380 time(s))

• Attachment: ETS35 H39 instructions.jpg
  (Size: 551.18KB, Downloaded 361 time(s))

[Updated on: Sun, 09 June 2013 09:05 UTC]

Here are the instructions for ETS35007. More details will follow later.

However it might already be important to know this:
- Parts 21 can be used the holes in the idler (Part 22). These can simply be glued to the outside of the idler, but they are optional since not all R35s had these.
- Parts 28 and 29 are use to put Part 30 either in the closed or open position. You'll need some thing styrene rod or wire to attach these to Part 27
- When installing Part 37, make sure it ends up in a horizontal position. The upper hull of the R35 slopes down towards the rear, suggesting Part 37 should do the same, but it shouldn't.

• Attachment: ETS35007 - Manual R35 Set - Bogies.jpg
  (Size: 93.82KB, Downloaded 11 time(s))

• Attachment: ETS35007 - Manual R35 Set - Parts.jpg
  (Size: 237.31KB, Downloaded 12 time(s))