Home »  » 3D Printing » Little People!
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Little People! [message #52704] Thu, 16 August 2012 12:00 UTC Go to next message
avatar On30  is currently offline On30
Messages: 2
Registered: December 2011
Go to all my models
Junior Member
Is it cost effective to 3D print miniature people? Or perhaps print a set as a master then cast from them? How detailed can 3d printing get if the subject is HO scale (1/87) and only 13/16" tall?
Re: Little People! [message #52796 is a reply to message #52704 ] Fri, 17 August 2012 22:48 UTC Go to previous message
avatar Dragoman  is currently offline Dragoman
Messages: 173
Registered: August 2011
Go to my shop
Senior Member
Check out the various shops with miniatures of people (or similar sized, robots, aliens, fantasy beings etc.) here on Shapeways.

My impression is that up to about 25-30 mm tall figures the prices per figure is similar to what you per for similar metal figures. And I have seen good figures down to 1/144 scale or less.

Greetings
Dragoman

[Updated on: Fri, 17 August 2012 22:48 UTC]


 
   
Previous Topic:Sandstone Texture mapping Questions
Next Topic:Just how flexible is "Flexible Plastic"?

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.