|Moebius Cup [message #52642] Wed, 15 August 2012 17:33 UTC
I received my Moebius Cup.
It's a small coffee cup whose handle is a Moebius strip.
It is only attached on one side (where it is horizontal): I guess such a shape should be difficult to do without 3D-printing.
Oddly enough, it is quite ergonomic: put your thumb on the vertical part of the Moebius strip, put the opposite horizontal part between your index and your medium, et voilà!
I hope you will like it!
So many things to design, so little time...
To see more of my dice mass-produced, please, visit this Kickstarter!