Home » Community » 3D modeler needed » Worm gear needed - see technical drawing
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Worm gear needed - see technical drawing [message #52009] Fri, 27 July 2012 23:51 UTC
avatar timpmandan  is currently offline timpmandan
Messages: 2
Registered: July 2012
Go to my shop
Junior Member
Hello all,
I'm very new to this whole 3d printing thing, but I'm betting it will work for a particular part I need replaced in a vintage Bodine motor. The right angle worm gear was mashed on 3 teeth and I found an original technical drawing that gives every detail needed. I'm curious if I could convince someone to give this a shot for me? I can tap the set screw holes if printing threads is not easy. See drawing.

  • Attachment: 25815474.jpg
    (Size: 1.45MB, Downloaded 101 time(s))


 
   
Previous Topic:Need someone to finish my project - really simple and quick
Next Topic:3D modeler needed to create 3D models of some rings/coins