Home » Community » Work in progress » Sake & Espresso Spiraling Tower Cup
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Sake & Espresso Spiraling Tower Cup [message #51522] Wed, 18 July 2012 12:53 UTC Go to next message
avatar opresco  is currently offline opresco
Messages: 165
Registered: April 2010
Go to my shop
Senior Member
index.php?t=getfile&id=18638&private=0

Sake & Espresso Spiraling Tower Cup
http://shpws.me/aRse



cascador
Re: Sake & Espresso Spiraling Tower Cup [message #51524 is a reply to message #51522 ] Wed, 18 July 2012 13:24 UTC Go to previous messageGo to next message
avatar pfeiffer stylez  is currently offline pfeiffer stylez
Messages: 296
Registered: August 2011
Go to my shop
Senior Member
The rotating 3d view is somehow hypnotic... http://cheesebuerger.de/images/smilie/konfus/a085.gif
Re: Sake & Espresso Spiraling Tower Cup [message #51778 is a reply to message #51522 ] Tue, 24 July 2012 14:52 UTC Go to previous messageGo to next message
avatar jeff  is currently offline jeff
Messages: 321
Registered: July 2008
Go to my shop
Senior Member
dig the spirals, but I'd be a bit concerned about the legs holding the cup weight pre firing... I had this printed fine http://www.shapeways.com/model/259920/cupo-3.html with 3mm thick by 5mm wide legs at the skinniest point.

good luck


Jeff Bare
Industrial Designer
@jbaredesign
Re: Sake & Espresso Spiraling Tower Cup [message #51827 is a reply to message #51778 ] Wed, 25 July 2012 12:34 UTC Go to previous message
avatar opresco  is currently offline opresco
Messages: 165
Registered: April 2010
Go to my shop
Senior Member
They are 3mm at the thinnest.

I just ordered my first test print from this series. (see link below).
I'll post the results when/if they'll print it as such.
http://www.shapeways.com/forum/index.php?t=msg&th=10169& amp;start=0&

Thanks,
Ovidiu


cascador

 
   
Previous Topic:Model Errors
Next Topic:Rectangular Sake & Espresso Tower Cup