Flower Dice - It arrived! on Shapeways Discussions about 3D Printing

Home » Community » It arrived! » Flower Dice

Flower Dice [message #51296] Sat, 14 July 2012 00:01 UTC

WillLaPuerta
Messages: 127
Registered: May 2010
Go to my shop

Senior Member

I made a dodecahedron out of tessellating flowers a while back and thought, "I bet I could make a set of dice like that." So I did.

Here's a group photo:

http://images1.sw-cdn.net/model/picture/674x501_574565_492523_1342222633.jpg

Here's a closeup of the D4:

http://images1.sw-cdn.net/model/picture/674x501_574565_492550_1342223258.jpg

The D6:

http://images1.sw-cdn.net/model/picture/674x501_574565_492551_1342223260.jpg

The D8:

http://images1.sw-cdn.net/model/picture/674x501_574565_492552_1342223263.jpg

The D10:

http://images1.sw-cdn.net/model/picture/674x501_574565_492553_1342223266.jpg

The D12:

http://images1.sw-cdn.net/model/picture/674x501_574565_492554_1342223269.jpg

The D20:

http://images1.sw-cdn.net/model/picture/674x501_574565_492555_1342223271.jpg

I think I'm going to coat them all in a protective clear coat and hope that will keep them from chipping too easily, but I probably still won't be rolling them on hard surfaces.

[Updated on: Tue, 24 July 2012 00:03 UTC]

"I am just a humble servant with a message here for you"

Report message to a moderator

Profile PM

Reply Quote

Re: Flower Dice [message #51331 is a reply to message #51296 ] Sat, 14 July 2012 19:20 UTC