Interlocking Rings in Glossy Silver - It arrived! on Shapeways Discussions about 3D Printing

Home » Community » It arrived! » Interlocking Rings in Glossy Silver

Interlocking Rings in Glossy Silver [message #51239] Thu, 12 July 2012 18:00 UTC

lensman
Messages: 1191
Registered: December 2009
Go to my shop

Senior Member

My custom requested interlocking rings arrived yesterday and will be in the mail to the buyer today... Thought I'd give you guys a look-see. If I had to re-design these I'd make the outer "arms" thicker as that silver is very thin... but the design works, anyway.

Glenn

index.php?t=getfile&id=18442&private=0

Attachment: interlocking rings1.jpg
(Size: 615.13KB, Downloaded 233 time(s))
Attachment: interlocking rings2.jpg
(Size: 623.76KB, Downloaded 241 time(s))
Attachment: interlocking rings3.jpg
(Size: 617.70KB, Downloaded 230 time(s))

Glenn ------ My Website Third Dimension Jewellery

Report message to a moderator

Profile PM

Reply Quote

Re: Interlocking Rings in Glossy Silver [message #51275 is a reply to message #51239 ] Fri, 13 July 2012 13:41 UTC

bdeaver
Messages: 28
Registered: August 2010
Go to my shop

Junior Member

That's a great design! It's good to hear your redesign ideas for the next version. That second photo, with the overlap, would make a nice pendant or earring done as a single object. It shows the relationship of the two without being completely closed.

bobd

Report message to a moderator

Profile PM

Reply Quote

Re: Interlocking Rings in Glossy Silver [message #51278 is a reply to message #51239 ] Fri, 13 July 2012 14:23 UTC

lensman
Messages: 1191
Registered: December 2009
Go to my shop

Senior Member

Thanks, and yes, that's not a bad idea... perhaps also a pendant and/or ring / earring worn by same person?
Glenn

[Updated on: Fri, 13 July 2012 14:25 UTC]

Glenn ------ My Website Third Dimension Jewellery

Report message to a moderator

Profile PM