Home »  » 3D Printing » Help! I got Thin Walls!
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Help! I got Thin Walls! [message #85636] Fri, 28 February 2014 23:01 UTC Go to next message
avatar Plumguy  is currently offline Plumguy
Messages: 29
Registered: November 2010
Go to my shop
Junior Member
Anyone able to help me fix my thin walls?
I fixed most of it but there is one part of the dome segment has an area that is still too thin.
For the life of me I can't figure out why it is thin or how to fix it. Is the angle a problem?
Help! ----- please!

[Updated on: Fri, 28 February 2014 23:12 UTC]

Re: Help! I got Thin Walls! [message #85638 is a reply to message #85636 ] Fri, 28 February 2014 23:23 UTC Go to previous message
avatar Plumguy  is currently offline Plumguy
Messages: 29
Registered: November 2010
Go to my shop
Junior Member
Nevermind! I flattened-out the center-point on the dome segment.
That seemed to fix the problem. Must have been too sharp of an angle!
:D

 
   
Previous Topic:ABS material available?
Next Topic:Elasto-Plastic Flexibility

Logo

Hello.

We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.