| Using STL files Help required! [message #8228] Fri, 11 December 2009 02:35 UTC |
 |
|
I use varicad for 3d
I drew a manifold , and its not very watertight
I then used various meshing programs , meshlabs, Gmsh, netgen
I use these for Calculix ( an engineering software )
The manifold meshed well in Netgen and Gmsh
but in Blender if was 100 non manifold , full of problems ( 1 or 2 I can accept but this would be quicker to redraw ! )
So it maybe the output of Varicad ?
anyway any suggestions to produce a watertight drawing?
Stephen
Attachment: model.jpg
(Size: 161.53KB, Downloaded 181 time(s))
|
|
|
| Re: Using STL files Help required! [message #8236 is a reply to message #8228 ] Fri, 11 December 2009 11:05 UTC |
 |
|
Hi Stephen,
it's hard to tell from an image - could you send the file to service@shapeways.com? We'll see what we can do for you.
Cheers,
Bart
Community Manager Europe | Shapeways
|
|
|
Search
