Home » Community » 3D modeler needed » Need to convert an existing model to STL and scale it for 3D printing
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
Need to convert an existing model to STL and scale it for 3D printing [message #68811] Wed, 29 May 2013 01:56 UTC
avatar skeletonx  is currently offline skeletonx
Messages: 3
Registered: December 2012
Go to all my models
Junior Member
I have purchased a 3D file from turbosquid of a skull and would like some one to convert it to STL, scale it down to about 15mm on a side, add a vertical center hole, and make some additional adjustments (optimize) to make it ready for 3-D printing using Kraftwurx. Kraftwurx has the finished material required.

PM me if you have experience doing the above.

 
   
Previous Topic:3D modeler needed for a innovative sports bottle
Next Topic:Custom modeler needed for "Pregnant Woman - Fetus" Piece