Search Search  
Show: Today's Messages    Show Polls    Message Navigator
molding [message #68371] Mon, 20 May 2013 18:42 UTC Go to next message
avatar omersianto  is currently offline omersianto
Messages: 2
Registered: May 2013
Go to all my models
Junior Member
Hi,
I want to print a jewelry model and after i want to send it for rubber or silicon mold.
Do some one know if i can use the Strong & Flexible Plastic so i will be able to send it for molding ? if not can some one recommend which material will be best for it?

Thank you for the help,
Omer.
Re: molding [message #68374 is a reply to message #68371 ] Mon, 20 May 2013 19:03 UTC Go to previous messageGo to next message
avatar BillBedford  is currently offline BillBedford
Messages: 346
Registered: November 2008
Go to all my models
Senior Member
You can use WSF, but FUD will give a better definition and surface finish. You will have to use RTV silicon for the mould as both WSF and FUD will have problems with heat vulcanising.


Bill Bedford
Re: molding [message #68389 is a reply to message #68374 ] Mon, 20 May 2013 23:38 UTC Go to previous message
avatar omersianto  is currently offline omersianto
Messages: 2
Registered: May 2013
Go to all my models
Junior Member
Thank you very much for your quick replay,
I'm new with the materials and i don't know which one you mean when you wrote WSF or FUD.

Thank you again,
Omer.

 
   
Previous Topic:premium silver
Next Topic:Reinforcing Thin walls white plastic