Home » Support » 3D Printing » is this bad for 3d printing?
Search Search  
Show: Today's Messages    Show Polls    Message Navigator
is this bad for 3d printing? [message #67298] Wed, 01 May 2013 21:37 UTC
avatar graf1ty  is currently offline graf1ty
Messages: 2
Registered: January 2013
Go to my shop
Junior Member
I already ordered the model on shapeways, but found an 'artifact' inside the what would be printed segment...

free image hosting

would that cause printing errors or will it be printed ok?

Previous Topic:-closed-
Next Topic:Fullcolor Sandstone blender exporting X3D problem